GRAPHTEC CE7000 Series - Page 347

A-19
Menu items Setting item Initial value
DATA LINK
(LINK)
DESTINATION USB DRIVE
START MARK AUTO SCAN OFF
COMMUNICATION TIME OUT 10sec
AUTOMATIC SKEW DETECTION 10mm
TOOL
SETTING
(Condition)
CONDITION 1 Condition No. Condition No. 1
TOOL CB09U
SPEED 30
FORCE 14
ACCELERATION 2
ASSIGN TOOL 1
TANGENTIAL MODE OFF
OVERCUT (START) 0
OVERCUT (END) 0
DISTANCE ADJUST OFF
INITIAL DOWN FORCE 0
CUT LINE PATTERN OFF
CONDITION 2 Condition No. Condition No. 2
TOOL PEN
SPEED/FORCE/ACCELERATION 30/12/2
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 3 Condition No. Condition No. 3
TOOL CB09U
SPEED/FORCE/ACCELERATION 30/12/2
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 4 Condition No. Condition No. 4
TOOL CB09U
SPEED/FORCE/ACCELERATION 20/17/1
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 5 Condition No. Condition No. 5
TOOL CB09U
SPEED/FORCE/ACCELERATION 60/17/3 (CE7000-40)
64/17/3 (CE7000-60)
71/17/2 (CE7000-130/160)
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 6 Condition No. Condition No. 6
TOOL CB09U
SPEED/FORCE/ACCELERATION 10/22/2
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 7 Condition No. Condition No. 7
TOOL CB09U-K60
SPEED/FORCE/ACCELERATION 30/17/2
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
CONDITION 8 Condition No. Condition No. 8
TOOL CB15U
SPEED/FORCE/ACCELERATION 5/30/1
Same as Condition No. 1 from CUT LINE
PATTERN to INITIAL DOWN FORCE
Same as Condition No. 1
* Setting items and initial values may be changed.