GRAPHTEC CE7000 Series - Page 86

2-54
Supplement
•
Tool number and installed position
Tool Holder
(Backward: Half cut/Plotter pen)
Tool Holder
(Forward: Cutting out)
Tool 1: When using a tool installed behind
the tool holder
Tool 3: When using a tool attached in front of
the tool holder
•
For information on how to install the tool, see
"Attaching a Tool".
5
Press the [1] key (1) or the [3] key (3).
6
Conrm the setting and press the [ENTER] key (SET).
Setting will be conrmed and it will return to CONDITION setting screen
(2/3).
7
Press the [COND/TEST] key.
It will return to default screen.