GRAPHTEC CELITE-50 - 6.2 Confirming Error Messages

6-3
Chapter 6 Troubleshooting
6.2 Conrming Error Messages
GP-GL Command Errors
Error No. Displayed Solution
E02001
An order that cannot be recognized was forwarded.
Touch the
(Conrm).
Noise was input when the computer was turned ON.
In the menu of the software, perform settings for
operating the device.
The setting for the device the software will output to
has changed.
Fix the setting of the software interface.
The settings on the plotter's interface have changed. Fix the settings on the plotter's interface.
E02004
A numerical parameter of a command has exceeded
the acceptable range.
In the menu of the software, perform settings for
operating the device.
The setting for the device the software will output to
has changed.
Fix the setting of the software interface.
The settings on the plotter's interface have changed. Fix the settings on the plotter's interface.
E02005
An error related to receipt of data has occurred within
the interface.
In the menu of the software, perform settings for
operating the device.
The setting for the device the software will output to
has changed.
Fix the setting of the software interface.
The settings on the plotter's interface have changed. Fix the settings on the plotter's interface.
E02006
Data that exceeds the cutting area has been
received.
Conrm the data.
Conrm the size and cutting area of the media.
Conrm the settings for the scale.
Conrm the settings for the size of steps.
HP-GL Command Errors
When an HP-GL command error is displayed, the cause of such in most cases is one of the two reasons listed
below.
•
The setting for the model the application software will output to has changed.
•
The settings on the interface of the device have changed.
If one of these reasons has caused the error, take the measures listed below to resolve the problem.
•
Fix the setting for the model the application software will output to.
•
Fix the settings on the interface of the device.
Error No. Displayed Solution
E03001
Error 1
An order that cannot be recognized was executed. Execute a command that can be used.
E03002
Error 2
The value of a parameter was incorrectly specied. Execute the command with a proper value for the
parameter.
E03003
Error 3
A parameter that cannot be used was executed. Execute a parameter that can be used.
E03005
Error 5
A character set that cannot be used was specied. Specify a character set that can be used.
E03006
Error 6
The coordinates of a command have been specied
outside of the cutting area.
Execute the command with coordinates within the
cutting area.
E03007
Error 7
An overow of the buffer memory has occurred while
processing the downloadable character buffer or
polygon buffer, etc.
Adjust the buffer size.
E03010
Error 10
While executing an output order, another output order
was executed.
Check the program.