GRAPHTEC CELITE-50 - Setting the Tool

2-3
Chapter 2 Basic Operations
Setting the Tool
To attach the tool, insert the tool into the tool holder completely, and then x the tool by the locking lever.
CAUTION
•
Don't touch to the tool while it is moving, it is extremely dangerous.
•
Be careful not to injure yourself with the cutter blade when setting the tool.
1. Pull the locking lever to open the lock.
Locking Lever
Locking
indicator
LockUnlock
2. Insert the cutter pen to the tool holder while holding it.
Locking Lever
3. Push the locking lever until it clicks to hold the cutter pen.
Conrm the locking indicator became the white.
Locking Lever
Locking
indicator
LockUnlock
Click
4. Pull the locking lever to open the lock, and then remove the
cutter pen from the tool holder.
Locking Lever