GRAPHTEC CELITE-50 - 4.4 Cutting from a USB Memory; Saving Data on a USB Memory; Cutting upon Loading USB Memory Data

4-17
Chapter 4 Convenient Functions
4.4 Cutting from a USB Memory
Select an .xpf le / plot le saved on a USB memory to perform ofine output.
Saving Data on a USB Memory
Create cutting data and save this on a USB memory.
•
Files other than les with the extension ".xpf" created using Graphtec Pro Studio or Cutting Master 4 and ".plt"
plot les for GP-GL-or HP-GL will not be displayed.
•
Only single-byte alphanumeric characters (ASCII) are supported for the le names and folder names.
•
Characters prohibited in Windows ( ¥ / : * ? " < > | \ ) cannot be used in the le names.
•
The maximum number of characters that can be displayed is 25. Names exceeding this length will be scrolled
to be displayed.
•
Folders are indicated by a folder icon displayed at the beginning of the name.
•
The folders and les are listed in order of their names in the ascending order.
•
A maximum of 64 folders/les can be acquired.
Cutting upon Loading USB Memory Data
USB Memory
1. Insert a USB memory on which cutting data is saved into
the device.
2. Load the media and the tool and select the CONDITION
NO.
3. On the "HOME" screen, touch the (USB).
4. Touch the "SELECT FILE".
5. Select a le and conrm the selection with
the
(Conrm).
Touch the (Thumbnail) to display
thumbnails
(limited to ".xpf" les that
contain thumbnail information).
6. Touch the (Position) to open the "MOVE
POSITION" screen.
7. Use the " ", " ", " ", and " " to move the
tool to the cut starting position and touch
the (Origin).
8. When the "START CUTTING" is touched,
the device will start cutting.