GRAPHTEC CELITE-50 - 1.7 Connecting and Turning ON the Power

1-9
Chapter 1 Notes Before Use
1.7 Connecting and Turning ON the Power
Connect this device and the AC outlet via the standard accessory of AC adapter, and then turn ON the power.
1. Connect the AC adapter and the AC cable (1). Connect the AC adapter to the power supply connector of
this device (2). Connect the AC cable to the AC outlet of specied voltage (3).
(2)
AC Adapter
AC Cable
(1)
(3)
2. Press the power switch to turn ON the power.
Conrm that the touch panel has started up.
When turning ON the power, wait at least 20 seconds to turn
on the power after the power was turned OFF.
The device may fail when immediately the power turned ON,
after the power was turned OFF.
•
After the power was turned ON when the media set lever
was not set, the "SET THE MEDIA SETTING LEVER." is
displayed.
At this time, lower the set lever, and then the "LOAD MEDIA" is displayed.
Then touch the
(Exit) to exit to the HOME menu.