4-10
Chapter 4 Convenient Functions
Loading Media onto the Carrier Sheet
•
When loading media onto the carrier sheet, be sure to load the media within the range that can be cut
(adhesive surface).
•
Load the media so that it is parallel with the adhesive surface.
•
When attaching the media, rmly press down to prevent bubbles, wrinkles, and peeling.
•
Attach the media onto the carrier sheet upon making sure that the media is not excessively curled. Using
stiff media that is curled can cause problems such as registration mark scanning errors and the media itself
getting caught on something.
1. Peel the separator on the carrier sheet and expose the
surface with adhesion.
Do not throw away the separator as it will be used for
storage.
Separator
Carrier Sheet
Peel the Separator
2. Attach the media to the adhesive area of the carrier sheet.
Attach the media so that it is straight in reference to the
origin marking on the top left of the carrier sheet.
Media
Adhesive Area
Carrier Sheet
Media
Origin Marking
To Next Page
Loading...
