GRAPHTEC CELITE-50 - 4.6 Cutting upon Specifying the Cutting Position

4-22
Chapter 4 Convenient Functions
4.6 Cutting upon Specifying the Cutting Position
Set the position at which to start cutting (cutting origin). The cutting origin can be set at any position.
Once you are done with the setting, touch the
(Exit) to return to the "HOME" screen.
X
Y
Original Origin
New Origin
1. Touch the (Position) to open the "MOVE POSITION" screen.
2. Use the " ", " ", " ", and " " to move the tool to the position
of the new origin and touch the
(Origin) to set the cutting
origin.