GRAPHTEC CELITE-50 - Setting the Overcuts

5-10
Chapter 5 Detailed Settings
Setting the Overcuts
Set the lengths of the overcuts created when using the tangential mode.
An overcut length can be set for each the start and end of the lines.
Congurable range: 0.0 - 0.9 (mm)
1. Touch the (CONDITION) on the "HOME"
screen to open the CONDITION NO.
setting screen.
2. Select the CONDITION NO. to set by using
the "
" and " " and touch the "OVERCUT
START".
3. Use the " " and " " to select the setting
value and conrm the selection with the
(Conrm).
4. Touch the "OVERCUT END".
5. Use the " " and " " to select the setting
value and conrm the selection with the
(Conrm).