GRAPHTEC CELITE-50 - 1.5 Media Size and Cutting Area; Compatible Media Sizes; Cutting Area

1-7
Chapter 1 Notes Before Use
1.5 Media Size and Cutting Area
Compatible Media Sizes
This cutter is able to use only width of standard media size as shown in the table below.
Use the carrier sheet when the media width is other than below.
For more information on the carrier sheet, refer to "4.2 Cutting using the Carrier Sheet".
Compatible
Media Width
Size
Position of right side
Media Set Lever
ISO A/JIS A JIS B ISO B Inch Non-Standard
210.0mm A4
1
215.9mm 8.5inch
220.0mm OK
250.0mm B4
257.0 mm B4
279.4mm 11inc h
297.0 m m A3
304.8mm 12inch
2
320.0mm OK
329.0mm A3+
353.0mm B3
364.0mm B3
381.0mm 15inch
420.0mm A2
431.8mm 17inch
3500.0mm B2
508.0mm 20inch
Cutting Area
The cutting area and cutting direction will be as shown below.
Sheet Media Roll Media
10mm 10mm
Cutting Area
5mm30mm
When margin is normal
5mm 5mm
Cutting Area
5mm
30mm
When margin is narrowed
Sheet Media
15mm 15mm
Cutting Area
5mm
When margin is normal
5mm 5mm
Cutting Area
5mm
When margin is narrowed
Sheet Media