2-12
Chapter 2 Basic Operations
Notes regarding the Cutting Area
The cutting area will vary depending on the media and the settings for "Cutting Area". Create cutting data in
reference to the following:
Media: Sheet media
Tilt correction:
Enabled/Disabled
, Margin: Normal
Media: Sheet media
Tilt correction:
Enabled/Disabled
, Margin: Expanded
Front Edge: 5 mm / Left/Right: 10 mm / Rear Edge: 30 mm
X
Y
10mm10mm
5mm
30mm
Cutting Area
Media Transport Direction
Front Edge: 5 mm / Left/Right: 5 mm / Rear Edge: 30 mm
X
Y
5mm5mm
5mm
30mm
Cutting Area
Media Transport Direction
Media: Carrier sheet
Margin: Normal/Expanded
Front Edge: 5 mm / Left/Right: 5 mm / Rear Edge: 5 mm
Media Transport Direction
X
Y
5mm5mm
5mm
5mm
Cutting Area
•
For information on how to change the margin settings, refer to "4.7 Expanding the Cutting Area".
•
For more information on the carrier sheet, refer to "4.2 Cutting using the Carrier Sheet".
To Next Page
Loading...
