GRAPHTEC CELITE-50 - Setting the Cutting Force; Setting the Offset Force

5-4
Chapter 5 Detailed Settings
Setting the Cutting Force
Set the cutting force to use the tool with. Adjust this value if the cuts are too shallow or too deep.
Congurable range: 1 - 26
1. Touch the (CONDITION) on the "HOME"
screen to open the CONDITION NO.
setting screen.
2. Select the CONDITION NO. to set by using
the "
" and " " and touch the "FORCE".
3. Use the " " and " " to select the cutting
force and conrm the selection with the
(Conrm).
Setting the Offset Force
Set the cutting force for initial control (offset force) that is performed during initial operations in order to conrm
the orientation of the blade tip. If the offset force is too weak, the orientation of the blade may be unstable at
the beginning of the cut and cause the starting point and ending point to not match up.
The offset force is also used as the cutting force when performing rotary control of the blade tip when operating
in the tangential mode.
Congurable range: 1 - 26
1. From the "MENU" screen, open the "TOOL
1/2" screen.
2. Touch the "OFFSET FORCE".
3. Use the " " and " " to select the offset
force and conrm the selection with the
(Conrm).