3-15
Chapter 3 Cutting along Printed Data
Graphtec Studio
[1] Creating the registration marks
Margin
X
Y
Media Transport Direction
1. From the "Registration Marks" tab in Graphtec Studio, create registration
marks over the design.
A margin is required at the edge of the media when creating the
registration marks. As the printing position may vary depending on the
printer used to print the design, it is recommended that a few extra
millimeters be allowed for the margin.
2. Specify the registration mark pattern, length, line thickness, and
arrangement positions.
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
3. Registration marks will be created over the design.
[2] Creating data for printing & cutting
Cutting Data
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
1. Create printing data and cutting data for printing & cutting.
Create the cutting data upon specifying a color that is not
used in the printing data.
To Next Page
Loading...
