GRAPHTEC CELITE-50 - Page 50

3-14
Chapter 3 Cutting along Printed Data
[4] Cutting the printed media
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
1. Load the printed media onto CE LITE-50.
(Refer to "2.4 Loading Sheet Media")
2. When using Illustrator, access the File menu and select "Cutting Master4" – "Cut / Plot".
When using CorelDRAW, go to the tool bar and select "Launch" – "Cut / Plot (CM4)".
•
When using a version of CorelDRAW that is X7 or earlier, this can be selected from the application
launcher.
Before selecting the cutting plot, set the layer containing the printing data to be hidden.
3. The "Cut / Plot" screen will launch.
In order to match the orientation in which the
media has been loaded, set ROTATE to "
".
•
When the "Cut / Plot" screen is displayed
for the rst time, the "Add Device" screen
will be displayed.
Follow the on-screen instructions to select
"CE LITE-50" for the model name and
"Graphtec USB" for the connection
destination.
4. Click the "Send".
Move tool
here
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
5. A conrmation screen will appear.
Move the tool to the registration mark (red square) at the top
left and click the "OK".
Scanning of the registration marks will begin, and once all
of the registration marks have been scanned, the cutting will
begin.