2-8
Chapter 2 Basic Operations
Loading the Media upon Releasing the Push Rollers
1. Raise the media set levers and release the push rollers.
2. Set the push roller on the left side at the position of the " " mark.
Set the push roller on the right side according to the width of the sheet media.
3. Insert the front edge of the sheet media in until it reaches the cutting mat (white translucent mat) behind
the push rollers.
Pass the sheet media under the push roller positioning guide and load it so that it is parallel with the front
guide.
If the sheet media is inserted too far, there may be cases when the media cannot be scanned.
Sheet Media
Cutting Mat
Push Roller
Edge of Sheet Media
Set to be parallel
Front Guide
Sheet Media
Push Roller
Edge of Sheet Media Cutting Mat
Push Roller
4. Align the left edge of the sheet media with the " I " marking of the " " mark on the front guide.
Sheet Media / Carrier Sheet Marking Sheet Media
Front Guide
5. Lower the media set levers on both sides and lock the push rollers.
6. On the "HOME" screen, touch the "LOAD MEDIA".
When the "SHEET" is touched, the width, front edge, and rear
edge of the media are scanned and the sheet media is loaded.
If an error is displayed, operate the device by following the on-
screen instructions.
CAUTION
When the "SHEET" is touched, the media and tool carriage will
start moving. Be careful to avoid contact with your body or any
object.
To Next Page
Loading...
