GRAPHTEC CELITE-50 - 4.5 Cutting Multiple Media using the Same Data (Copy Function); Copying Multiple Cuts on a Single Media

4-19
Chapter 4 Convenient Functions
4.5 Cutting Multiple Media using the Same Data (Copy Function)
Using cutting data retained in the buffer memory, a cut can be repeated for a specied number of times.
•
Refrain from sending new data while copying is in progress. Doing so will erase the cutting data in the buffer
memory.
•
Data with a size of 1.6 MB or larger cannot be copied as it will not t in the buffer memory of this device.
•
If the position of the cutting data at the copying source is far away from the origin, the copied cutting will
similarly consist of cutting far away from the origin. In order to eliminate wasteful margins, create cutting data
to be as close as possible to the origin.
•
The data of layout registration marks cannot be copied.
Copying Multiple Cuts on a Single Media
A cut can be performed for a set number of times on a single media.
•
Be careful so that the cut does not overow from the media.
X
Y
Origin
Spacing for Copies
Spacing
for Copies
1st
Copy
3rd
Copy
2nd
Copy
4th
Copy
Copy Origin
1. Perform the cut once with the data to copy. The cutting data will be retained in the buffer memory.
2. Touch the (Position) to open the "MOVE POSITION" screen.
3. Use the " ", " ", " ", and " " to move the tool to the copy
starting position and touch the
(Origin) to set the position.
4. On the "HOME" screen, touch the (COPY).
5. Touch the "OFF" in "MEDIA CHANGE MODE" and touch the
"NUMBER OF COPIES".