GRAPHTEC CELITE-50 - Confirming Registration

5-14
Chapter 5 Detailed Settings
Conrming Registration
Detect the state of the media being used and display the recommended conditions for such as the scan mode,
registration mark color, and registration mark base color to select.
Once you are done with the setting, touch the
(Exit) to return to the "HOME" screen.
Conrming the Media
The appropriate registration mark scanning conditions are calculated based on the state of the media and then
displayed.
1. Load media that is the same as the media that will actually be cut but has not yet been printed on.
2. From the "MENU" screen, open the "ARMS
1/2" screen.
3. Touch the "CHECK MARK SCAN".
4. Touch the "MEDIA CHECK".
Scan Starting
Position
50mm
50mm
X
Y
Media Transport Direction
5. Use the " ", " ", " " and " " to move the tool carriage
to the scan starting position (any position in the top left
corner) and touch the (OK).
6. The tool carriage will move and automatically detect the
state of the media.
With the scan starting position as a reference, the
sensor will move 50 mm along the Y-axis and 50 mm
along the X-axis to detect the state of the media.
7. The appropriate registration mark color will be calculated based on the state of the
media and then displayed on the screen.
ARMS MODE: The recommended scan mode of MODE 1/2/3 will be displayed.
ADJUST LEVEL: Ther recommended registration mark adjustment value will
be displayed.
MARK LINE COLOR: The recommended registration mark color will be displayed.
BASE PAINT COLOR: The recommended base color for the registration marks will
be displayed.
"BASE PAINT COLOR" may not be displayed depending on the results of the scan.