GRAPHTEC CELITE-50 - Page 93

5-15
Chapter 5 Detailed Settings
Conrming the Registration Marks
Actually detect the registration marks to conrm operation of registration mark detection.
1. Load the media on which the registration marks have been drawn.
2. From the "MENU" screen, open the "ARMS
1/2" screen.
3. Touch the "CHECK MARK SCAN".
4. Touch the "MARK LINE CHECK".
Scan Starting Position
Registration
Mark
Registration Mark
Type 2
Registration Mark
Type 1
X
Y
Media Transport Direction
5. Select the type of registration marks to scan, use the
" ", " ", " " and " " to move the tool carriage to the
scan starting position (the position of the red circle in
the image to the right) and touch the
(OK).
6. The tool carriage will move and automatically detect
the registration marks.
7. The result of the scan will be displayed on the screen.
MARK SCAN MODE: The currently set scan mode will be displayed.
RESULT: The scan result (OK/NG) will be displayed.
It may not be possible to detect the registration marks depending on the state of the base. In such case, run
the "MEDIA CHECK" function and try again with the recommended conditions.