1-6
Chapter 1 Notes Before Use
1.4
Installing the Main Unit
Installation Space
Secure enough space to install the device so that the cutting operation is not affected.
•
The space required to the front and rear of the device will vary depending on the size of the media being
used.
•
Refrain from placing obstacles in front of or behind the main unit that will interfere with transportation of the
media.
Installation Space when Using Carrier Sheets
296mm
934mm
834mm
311mm
50mm
100mm
When using the roll media stocker and installing the device on a table, use a table that is leveled and solid with
a top panel that is at least 934 × 502 mm in size.
•
When using roll media, refrain from placing obstacles in front of or behind the main unit that will interfere with
transportation of the media.
50mm
934mm
502mm
50mm
50mm
100mm
To Next Page
Loading...
