3-12
Chapter 3 Cutting along Printed Data
Cutting Master 4
[1] Creating the registration marks
Margin
X
Y
Media Transport Direction
1. Using the "Rectangle" tool in Illustrator or CorelDRAW, create a rectangle
over the design.
A margin is required at the edge of the media when creating the rectangle.
As the printing position may vary depending on the printer used to print
the design, it is recommended that a few extra millimeters be allowed for
the margin.
2. After selecting the rectangle, when using Illustrator,
access the File menu and select "Cutting Master4" –
"Registration Marks".
When using CorelDRAW, go to the tool bar and select
"Launch" – "Registration Marks (CM4)".
•
When using a version of CorelDRAW that is X7
or earlier, the registration marks screen will be
displayed when it is selected from the application
launcher.
•
The screen to the right is the screen that appears
when it is launched from Illustrator.
3. Specify the registration mark type, line thickness, and
length.
Place a check in "Convert rectangle".
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
4. Close the registration marks screen.
Registration marks will be created over the design.
To Next Page
Loading...
