GRAPHTEC CELITE-50 - Page 47

3-11
Chapter 3 Cutting along Printed Data
[4] Cutting the printed media
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
1. Load the printed media onto CE LITE-50.
(Refer to "2.4 Loading Sheet Media")
2. Click the "Cut Contour" icon.
3. The "Cut Contour" screen will launch.
In order to match the orientation in
which the media has been loaded, set
ROTATE to "
".
•
When the "Cut Contour" screen is
displayed for the rst time, the "Add
Device" screen will be displayed.
Follow the on-screen instructions to
select "CE LITE-50" for the model
name and "Graphtec USB" for the
connection destination.
4. Click the "Send".
Move tool
here
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
5. A conrmation screen will appear.
Move the tool to the registration mark (red square) at the top
left and click the "OK".
Scanning of the registration marks will begin, and once all
of the registration marks have been scanned, the cutting will
begin.