ii
Introduction
Precautions on Handling the Cutter Blade
This product uses a blade. In order to prevent injury accidents due to the blade, please be very careful when
handling the cutter blade such as when attaching the cutter pen to the main unit.
Cutter Pen
The tip is a sharp blade. Be careful not to use an excessive blade depth. In addition, refrain from protruding the
blade from the tip of the cutter pen when the cutter pen is not in use.
Cutter blade
After Attachment to the Main Unit
Refrain from touching the pen tip after the power has been turned ON and during operation as doing so is
dangerous.
Precautions After Turning the Power ON
The tool carriage and media that is set may suddenly move during work, immediately after work has ended,
and while conguring various settings. Keep hands, hair, and clothes, etc. away from moving parts and their
range of motion and refrain from placing objects on these places. When using the device, be very careful to
avoid injury due to getting hands, hair, or clothes, etc. caught in the device.
Notes regarding Warning Labels
The warning label shown below has been placed on the tool carriage of the device. Be sure to observe the
precautions listed.
Tool carriage
Notes regarding the Wording in This Manual
•
"Cutting" as used in this manual refers to the device operating to draw gures with a drawing pen or cut
media with the cutter pen.
•
"Media" as used in this manual collectively refers to paper, roll paper, sheet paper, and marking lm.
To Next Page
Loading...
