GRAPHTEC CELITE-50 - 3.3 Registration Mark Scanned Printing & Cutting

3-5
Chapter 3 Cutting along Printed Data
3.3 Registration Mark Scanned Printing & Cutting
With this method, cuts will be made upon scanning the registration marks (reference lines) drawn on the media.
High-precision cutting is realized with this method as displacement of the printing position is adjusted when
cutting the outline of a printed shape or when re-cutting media.
•
If the registration marks cannot be scanned due to a registration mark scanning error or when the positions
are off despite the registration marks being scanned, refer to "5.6 Registration Mark Scan Settings" and
change the settings.
1. Create printed media on which registration marks have been drawn (refer to "3.4 Types and Arrangement
of Registration Marks).
2. On the "HOME" screen, select the CONDITION NO. to use by using the " " and " "
and set the tool.
3. Load the printed media on which registration marks have been drawn.
4. Touch the (Position) to open the "MOVE POSITION" screen.
5. Use the " ", " ", " " and " " to move the tool to the
registration mark scan starting area.
If the current position of the tool is far away from the registration
mark scan starting area, it may take time to search for the
registration marks or the process may even end in an error.
Registration Mark Type 1 Registration Mark Type 2
X
Y
X
Y
Registration Mark
Scan Starting Area
Registration Mark
Scan Starting Area
Media Transport Direction Media Transport Direction
6. Touch the (Exit) to return to the "HOME" screen and perform the cutting operation.
7. To make multiple cuts, send the data while changing the media.
Printing & cutting will be performed according to the tilt when the printed media is set.