GRAPHTEC CELITE-50 - 5.2 Adjusting the Cutting Quality; Selecting the Tool and Setting the Offset Value

5-3
Chapter 5 Detailed Settings
5.2 Adjusting the Cutting Quality
The quality of the cut can be adjusted by setting the cutting conditions.
Conrm the quality of the cut in relation to the setting by actually performing a cut. For more details, refer to
"5.5 Performing Cut Tests".
Once you are done with the settings, touch the
(Exit) to return to the "HOME" screen.
Selecting the Tool and Setting the Offset Value
Select the tool according to the media to be cut.
Selectable items: "PM-BS-001 (standard accessory)", "PM-BS-002 (optional)"
"Pen (drawing)", "Other"
Cutter Pen
Axis of Rotation
of Tool
Cutter Offset Value
Blade
Position of
Blade Tip
The offset value is the positional error between the center of the cutter pen
body and the center of the blade tip. Adjust this value if the corners of a cut are
being cut excessively or not being cut properly. A standard offset value is set
for each type of pen. Make ne adjustments based on these standard offset
values (make adjustments in reference to 0 being the standard offset value).
Congurable range: -5 to +5
1. Touch the (CONDITION) on the "HOME" screen to open the
CONDITION NO. setting screen.
2. Select the CONDITION NO. to set by using the " " and " " and
touch the "TOOL".
3. Touch the "TOOL".
4. Select the tool to use and touch the (Conrm).
5. Touch the "OFFSET".
The "OFFSET" will not be displayed when "PEN" is selected for
the tool.
6. Use the " " and " " to select the offset value and conrm the
selection with the
(Conrm).