GRAPHTEC CELITE-50 - Positions for Registration Mark Arrangement

3-7
Chapter 3 Cutting along Printed Data
Positions for Registration Mark Arrangement
Registration marks are arranged on the edge of the media with a margin.
Registration Mark Type 1 Registration Mark Type 2
Unit: mm
Numbers within brackets
"( )" are for when the
margin is expanded
1132
10 (5) 10 (5)
1136
16 (11) 16 (11)
X
Y
Media Transport Direction
X
Y
The area required to scan the registration marks is as shown below.
•
When a plot other than a registration mark exists in the registration mark scanning area, the plot may be
mistaken for a registration mark.
•
Be sure to clean the media so that it is free of dirt and dust, etc. Dirt or dust may be mistaken for a
registration mark.
•
Create the registration marks using a contrast that is easy to scan such as black on white media. Adjust the
registration mark settings when using the media other than white or glossy media. (Refer to "5.6 Registration
Mark Scan Settings")
Unit: mm
6
6
6
6
Registration Mark Scanning Area Registration Mark Scanning Area
Registration Mark Type 2 Registration Mark Type 2
X
Y
Media Transport Direction
X
Y
•
If a registration mark scan error occurs, congure the registration mark scan settings. (Refer to "5.6
Registration Mark Scan Settings")
•
For details on creating registration marks using the dedicated application, refer to "3.5 Flow of Creating
Registration Marks to Cutting".