4-18
Chapter 4 Convenient Functions
Cutting Barcode-equipped Data
X
Y
Starting Mark
Barcode
Media Transport Direction
Barcodes for information regarding the output le can be created with
Cutting Master 4 and Graphtec Pro Studio, etc. in order for it to be printed
on the media together with the design and registration marks.
The printed barcode is scanned when cutting that particular media and the
corresponding cutting data (.xpf) within the USB memory is detected to
perform the cut.
1. Insert a USB memory on which cutting data is saved into
the device.
USB Memory
2. Load the tool and the media on which a barcode is printed
and select the CONDITION NO.
3. On the "HOME" screen, touch the (USB).
4. Touch the "BAR CODE CUT".
5. Use the " ", " ", " ", and " " to move the
tool to the position of the starting mark and
touch the
(OK).
The corresponding le will be detected from the USB memory and the device will start cutting.
CAUTION
When the "OK" is touched, the media and tool carriage will start moving. Be careful to avoid contact with
your body or any object.
To Next Page
Loading...
