GRAPHTEC CELITE-50 - 4.7 Expanding the Cutting Area

4-23
Chapter 4 Convenient Functions
4.7 Expanding the Cutting Area
The cutting area can be expanded by setting the margin for the media width.
When "EXPAND" is selected, the cutting area is expanded on the left and right sides compared to when
"NORMAL" is selected.
•
Although cutting at positions that overlap with the push rollers is possible when"EXPAND" is selected, the
push roller will be moving within the cutting area and this may prevent normal transport with certain types of
media.
•
Send cutting data after setting the margin. The cutting data in the buffer memory will be erased when the
margin is changed.
Once you are done with the setting, touch the
(Exit) to return to the "HOME" screen.
Sheet Media
When margin is normal
Cutting Area
Push Roller Position
10mm
30mm 5mm
When margin is narrowed
5mm
30mm 5mm
Cutting Area
Push Roller Position
Roll Media
When margin is normal When margin is narrowed
15mm 15mm
5mm
Cutting Area
Push Roller Position
5mm 5mm
5mm
Cutting Area
Push Roller Position
1. From the "MENU" screen, open the "AREA 1/2" screen.
2. For the margin, select "EXPAND".