GRAPHTEC CELITE-50 - 1.2 Names and Functions of Each Component

1-3
Chapter 1 Notes Before Use
1.2 Names and Functions of Each Component
Operation panel
Media set lever - right
Cutter groove
Push roller
Tool carriage
Media set lever - left
Media sensor
Roll media stocker
Power switch Power supply connector
USB memory-dedicated port USB interface
Push roller positioning guide
Front Guide
Tool holder
Push roller Media holding roller (movable)
Operation panel: Used to operate the device and congure various settings.
Media set lever-right: Used to raise/lower the push roller when setting media and x (3 positions) / release
the media. Adjust this lever according to the width of the media.
Media set lever-left: Used to raise/lower the push roller when setting media and x/release the media.
Push rollers: Touches the media to x/transport the media. Adjust this roller according to the type
and size of the media.
Push roller positioning guide:
Sets the push rollers at the position of the indicated marking.
Tool carriage: Drives the tool left/right and scans registration marks and barcodes.
Tool holder: Holds the tool and drives it up/down.
Media holding roller (movable):
Holds down media to prevent low cutting quality and malfunction of register mark
detection. Set it in the center or the most lifted part of the media.
Media sensor: Scans media.
Front Guide: Sets the media at the position of the indicated marking.
Roll media stocker: Holds roll media.
Power switch: Used to turn the power ON/OFF.
USB memory-dedicated port:
Used to connect and load data from a USB memory.
USB interface: Used to connect the device with a computer.
Power supply connector: Used to connect the power cable.
Cutter groove: Used when registrationping roll media with the cross cutter.