3-10
Chapter 3 Cutting along Printed Data
[2] Creating data for printing & cutting
X
Y
Registration Mark Type 1 Registration Mark Type 2
Media Transport Direction
1. Create data for printing & cutting.
2. Select the printing data, and then select "Effects" – "Contour
Cut...".
On the "Design Central" screen, select the offset for the outline.
Cutting Data
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
3. On the "Design Central" screen, click the " ".
Cutting data will be created over the design.
[3] Printing the created data
1. Print the created data.
CAUTION
Be careful to observe the following items as doing otherwise will lead to not being able to scan the
registration marks and perform the cutting.
•
Set the enlargement/reduction scale to 100%.
•
Set the printing position (center / bottom left, etc.) to "Do Not Change".
To Next Page
Loading...
