3-13
Chapter 3 Cutting along Printed Data
[2] Creating data for printing & cutting
Cutting Data
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
1. Create data for printing & cutting.
It is recommended that the printing data and cutting data be
created on separate layers.
[3] Printing the created data
1. Print the created data.
Before printing the data, set the layer containing the cutting data to be hidden.
CAUTION
Be careful to observe the following items as doing otherwise will lead to not being able to scan the
registration marks and perform the cutting.
•
Set the enlargement/reduction scale to 100%.
•
Set the printing position (center / bottom left, etc.) such that the relative positioning of the position of
the created document and the printed results are the same.
To Next Page
Loading...
