2-7
Chapter 2 Basic Operations
5. Evenly position the edge of the sheet media up against the push rollers. Pass the sheet media under the
push roller positioning guide and load it so that it is parallel with the front guide.
Sheet Media
Push Roller
Push Roller Edge of Sheet Media
Set to be parallel
Front Guide
Edge of Sheet Media Push Roller
Sheet Media
6. Align the left edge of the sheet media with the " I " marking of the " " mark on the front guide.
Sheet Media / Carrier Sheet Marking Sheet Media
Front Guide
7. The width, front edge, and rear edge of the media are scanned and the sheet media is loaded. If an error
is displayed, operate the device by following the on-screen instructions.
CAUTION
When the "SHEET" is touched, the media and tool carriage will start moving. Be careful to avoid contact
with your body or any object.
To Next Page
Loading...
