3-16
Chapter 3 Cutting along Printed Data
[3] Printing the created data
1. Print the created data.
CAUTION
Be careful to observe the following items as doing otherwise will lead to not being able to scan the
registration marks and perform the cutting.
•
Set the enlargement/reduction scale to 100%.
•
Set the printing position (center / bottom left, etc.) such that the relative positioning of the position of
the created document and the printed results are the same.
[4] Cutting the printed media
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
1. Load the printed media onto CE LITE-50.
(Refer to "2.4 Loading Sheet Media")
2. Open the "Congure Cut Job" panel.
From "Apply Conditions", select "By Color" and select the color to cut
along.
3. Open the "Page" panel.
In order to match the orientation in which the media has been loaded,
set ROTATE to "180°".
4. Open the "Cutters" panel.
5. Move the tool to the upper left registration mark (indicated
in red).
Move tool
here
Media Transport Direction
X
Y
Registration Mark Type 1 Registration Mark Type 2
6. Click the "Sent to Cutter".
Scanning of the registration marks will begin, and once all
of the registration marks have been scanned, the cutting will
begin.
To Next Page
Loading...
