GRAPHTEC CELITE-50 - Page 122

A-10
Appendix
Menu Item Setting Item Initial Value
TEST SELF TEST –
CUTTING PRO –
ADJUST WIDTH SENSOR –
DIAGNOSTICS –
TOOL COND. (CONDITION NO.) Setting Screen
Menu Item Setting Item Initial Value
CONDITION NO. 1 TOOL PM-BS-001
TOOL OFFSET +0
SPEED 30 cm/s
ACCELERATION 2
FORCE 14
TANGENTIAL MODE OFF
OVERCUT (START) 0.0 mm
OVERCUT (END) 0.0 mm
DISTANCE ADJUST OFF
DISTANCE ADJUST X, Y 0.00%
CONDITION NO. 2 TOOL / TOOL OFFSET PEN / (None)
SPEED / ACCELERATION / FORCE 10 / 2 / 12
From TANGENTIAL MODE to DISTANCE Same as CONDITION NO. 1
CONDITION NO. 3 TOOL / TOOL OFFSET PM-BS-001/+0
SPEED / ACCELERATION / FORCE 30 / 2 / 12
From TANGENTIAL MODE to DISTANCE Same as CONDITION NO. 1
CONDITION NO. 4 TOOL / TOOL OFFSET PM-BS-001/+0
SPEED / ACCELERATION / FORCE 20 / 1 / 17
From TANGENTIAL MODE to DISTANCE Same as CONDITION NO. 1
CONDITION NO. 5 TOOL / TOOL OFFSET PM-BS-001/+0
SPEED / ACCELERATION / FORCE 20 / 2 / 17
From TANGENTIAL MODE to DISTANCE Same as CONDITION NO. 1
CONDITION NO. 6 TOOL / TOOL OFFSET PM-BS-001/+0
SPEED / ACCELERATION / FORCE 10 / 2 / 22
From TANGENTIAL MODE to DISTANCE Same as CONDITION NO. 1
CONDITION NO. 7 TOOL / TOOL OFFSET PM-BS-001/+0
SPEED / ACCELERATION / FORCE 30 / 2 / 17
From TANGENTIAL MODE to DISTANCE Same as CONDITION NO. 1
CONDITION NO. 8 TOOL / TOOL OFFSET PM-BS-001/+0
SPEED / ACCELERATION / FORCE 5 / 1 / 26
From TANGENTIAL MODE to DISTANCE Same as CONDITION NO. 1