4-5
Chapter 4 Convenient Functions
6. Evenly position the leading edge of the roll media up against the push rollers.
Pass the roll media under the push roller positioning guide and load it so that it is parallel with the Front
front guide.
Roll Media
Push Roller
Push Roller
Leading Edge of Roll Media
Set to be parallel
Front Guide
Leading Edge of Roll Media Push Roller
Roll Media
7. Align the left edge of the roll media with the "I" marking of the " " mark on the front guide.
Roll Media Marking Roll Media
Front Guide
8. The roll media is set after detecting the width and leading edge.
Operate the device by following the on-screen instructions when an error message appears.
CAUTION
When the "ROLL START EDGE" is touched, the media and tool carriage will start moving. Be careful to
avoid contact with your body or any object.
To Next Page
Loading...
