GRAPHTEC CELITE-50 - Page 7

v
Contents
2.7 Sending Cutting Data.................................................2-13
2.8 Ordinary Care ......................................................2-14
Cleaning the Cutter Pen .............................................2-14
Chapter 3 Cutting along Printed Data
3.1 What is Printing & Cutting? .............................................3-2
3.2 Simple Printing & Cutting ...............................................3-3
3.3 Registration Mark Scanned Printing & Cutting...............................3-5
3.4 Types and Arrangement of Registration Marks ..............................3-6
Registration Mark Shapes ............................................3-6
Positions for Registration Mark Arrangement..............................3-7
Automatic Registration Mark Position Detection ...........................3-8
3.5 Flow of Creating Registration Marks to Cutting ..............................3-9
Graphtec Pro Studio.................................................3-9
Cutting Master 4 ...................................................3-12
Graphtec Studio ...................................................3-15
Chapter 4 Convenient Functions
4.1 Cutting Roll Media ....................................................4-2
Assembling the Roll Media Stocker .....................................4-2
Loading and Scanning Roll Media ......................................4-4
Setting the Page Length..............................................4-8
4.2 Cutting using the Carrier Sheet ..........................................4-9
Loading Media onto the Carrier Sheet ..................................4-10
Loading the Carrier Sheet ...........................................4 -11
4.3 Plotting with the Drawing Pen ..........................................4-14
Setting the Drawing Pen in the Pen Adapter .............................4-14
Setting the Pen Adapter .............................................4-15
4.4 Cutting from a USB Memory ...........................................4-17
Saving Data on a USB Memory .......................................4-17
Cutting upon Loading USB Memory Data ...............................4-17
Cutting Barcode-equipped Data.......................................4-18
4.5 Cutting Multiple Media using the Same Data (Copy Function)..................4-19
Copying Multiple Cuts on a Single Media................................4-19
Copying Repeatedly on Multiple Media .................................4-21
4.6 Cutting upon Specifying the Cutting Position...............................4-22
4.7 Expanding the Cutting Area ............................................4-23
4.8 Aborting and Pausing during a Cut ......................................4-24
4.9 Withdrawing the Tool Carriage..........................................4-25
Chapter 5 Detailed Settings
5.1 Individually Registering Settings for Cutting Conditions .......................5-2
5.2 Adjusting the Cutting Quality ............................................5-3
Selecting the Tool and Setting the Offset Value............................5-3
Setting the Cutting Force .............................................5-4
Setting the Offset Force ..............................................5-4
Setting the Condition Priority ..........................................5-5