H3C S5100-SI

1-19
Task Remarks
Configuring Priority Trust Mode
Optional
Configuring Priority Mapping Optional
Setting the Priority of Protocol Packets
Optional
Configuring Priority Marking Optional
Configuring Traffic Policing Optional
Configuring Traffic Shaping Optional
Configuring Line Rate Optional
Configuring Traffic Redirecting Optional
Configuring VLAN Mapping
Optional
Configuring Queue Scheduling
Optional
Configuring Traffic Accounting Optional
Enabling the Burst Function Optional
Configuring Traffic Mirroring Optional
Configuring Priority Trust Mode
Refer to Priority Trust Mode for details about available priority trust modes.
Configuration prerequisites
z The priority trust mode to be used has been determined.
z The port where priority trust mode is to be configured has been determined.
z The port priority value has been determined.
Configuration procedures
1) Configuring a port to trust port priority
Follow these steps to configure a port to trust port priority:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Configure to trust port
priority and configure the
port priority
priority priority-level
Optional
By default, the switch
trusts port priority and
the priority of a port is 0.
2) Configuring a port to trust 802.1p precedence of traffic
Follow these steps to configure a port to trust 802.1p precedence: