H3C S5100-SI

1-40
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the burst
function
burst-mode enable
Required
Disabled by default
Configuration example
# Enable the burst function on an S5100-EI series switch.
<Sysname> system-view
[Sysname] burst-mode enable
Configuring Traffic Mirroring
Refer to Traffic Mirroring for information about traffic mirroring.
This feature is available only on the H3C S5100-EI series switches.
Configuration prerequisites
z The ACL rules for traffic classification have been defined. Refer to the ACL module of
this manual for information about defining ACL rules.
z The mirroring ports and mirroring direction have been determined.
z The monitor port has been determined.
Configuration procedures
You can configure traffic mirroring for incoming ACL matching packets globally, in a VLAN,
in a port group, or on a port.
1) Configuring traffic mirroring globally
Follow these steps to configure traffic mirroring globally:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the port as the
monitor port
monitor-port
Required
Return to system view
quit
—