H3C S5100-SI

5-7
View Available operation Prompt example Enter method Quit method
HWTACACS
view
Configure
HWTACACS
parameters
[Sysname-hwtac
acs-a123]
Execute the
hwtacacs scheme
command in
system view.
PoE profile
view
Configure PoE profile
parameters
Only S5100-PWR-EI
series switches
provide this view
[Sysname-poe-pr
ofile-a123]
Execute the
poe-profile
command in
system view.
Smart link
group view
Configure smart link
group parameters
[Sysname-smlk-g
roup1]
Execute the
smart-link group
command in
system view.
Monitor link
group view
Configure monitor link
group parameters
[Sysname-mtlk-g
roup1]
Execute the
monitor-link
group command in
system view.
Port-group
view
Configure port-group
parameters
Only S5100-EI series
switches provide this
view
[Sysname-port-gr
oup-1]
Execute the
port-group
command in
system view.
QinQ view
Configure QinQ
parameters
Only S5100-EI series
Ethernet switches
provide this view
[Sysname-Gigabi
tEthernet1/0/1-vi
d-20]
Execute the
vlan-vpn vid
command in
GigabitEthernet
port view.
The vlan-vpn
enable command
should be first
executed.
Execute the
quit command
to return to
GigabitEthernet
port view.
Execute the
return
command to
return to user
view.
The shortcut key <Ctrl+Z> is equivalent to the return command.
CLI Features
Online Help
When configuring the switch, you can use the online help to get related help information. The CLI
provides two types of online help: complete and partial.
Complete online help
1) Enter a question mark (?) in any view on your terminal to display all the commands available in the
view and their brief descriptions. The following takes user view as an example.
<Sysname> ?