H3C S5100-SI

1-13
To do… Use the command… Remarks
Configure the output rules
of system information
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to
Table 1-4 for the default
output rules of system information.
Set the format of time stamp
in the output information
info-center timestamp { log |
trap | debugging } { boot | date
| none }
Optional
By default, the time stamp format
of the output trap information is
date.
Setting to Output System Information to the Log Buffer
Follow these steps to set to output system information to the log buffer:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the information
center
info-center enable
Optional
Enabled by default.
Enable information output
to the log buffer
info-center logbuffer
[ channel { channel-number |
channel-name } | size
buffersize ]*
Optional
By default, the switch uses
information channel 4 to output log
information to the log buffer, which
can holds up to 512 items by
default.
Configure the output rules
of system information
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to
Table 1-4 for the default
output rules of system information.
Set the format of time stamp
in the output information
info-center timestamp { log |
trap | debugging } { boot | date
| none }
Optional
By default, the time stamp format
of the output log information is
date.
Setting to Output System Information to the SNMP NMS
Follow these steps to set to output system information to the SNMP NMS:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the information center
info-center enable
Optional
Enabled by default.
Enable information output to
the SNMP NMS
info-center snmp channel
{ channel-number |
channel-name }
Optional
By default, the switch outputs
trap information to SNMP
through channel 5.