H3C S5100-SI

2-13
Operation Command Description
Configure a shared FTP server
for the cluster
ftp-server ip-address
Optional
By default, the management
device acts as the shared FTP
server.
Configure a shared TFTP
server for the cluster
tftp-server ip-address
Optional
By default, no shared TFTP
server is configured.
Configure a shared logging
host for the cluster
logging-host ip-address
Optional
By default, no shared logging
host is configured.
Configure a shared SNMP host
for the cluster
snmp-host ip-address
Optional
By default, no shared SNMP
host is configured.
Configuring the network management interface for a cluster
This feature is only applicable to S5100-EI series switches.
1) Configuration prerequisites
z The cluster switches are properly connected;
z The shared servers are properly connected to the management switch.
2) Configuration procedure
Table 2-12 Configuring the network management interface for a cluster
Operation Command Description
Enter system view
system-view
—
Enter cluster view
cluster
—
Configure the network
management (NM) interface for
the cluster
nm-interface Vlan-interface
vlan-id
Required
By default, the management
VLAN interface is used as the
NM interface.
Configuring Member Devices
Member device configuration tasks
Table 2-13 Member device configuration tasks
Operation Description
Enabling NDP globally and on specific ports Required
Enabling NTDP globally and on a specific port Required