H3C S5100-SI

1-6
Figure 1-2 Process of displaying a shell banner
Follow these steps to configure the banner display for an FTP server:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure a login banner
header login text
Configure a shell banner
header shell text
Required
Use either command or both.
By default, no banner is
configured.
For details about the header command, refer to the Login part of the manual.
Displaying FTP server information
To do… Use the command… Remarks
Display the information about FTP server
configurations on a switch
display ftp-server
Display the source IP address set for an FTP
server
display ftp-server source-ip
Display the login FTP client on an FTP server
display ftp-user
Available in any
view
FTP Configuration: A Switch Operating as an FTP Client
Basic configurations on an FTP client
By default a switch can operate as an FTP client. In this case, you can connect the switch to the FTP
server to perform FTP-related operations (such as creating/removing a directory) by executing
commands on the switch.
Follow these steps to perform basic configurations on an FTP client: