H3C S5100-SI

2-3
To do... Use the command... Remarks
Disable the VLAN
interface
shutdown
Enable the VLAN
Interface
undo shutdown
Optional
By default, the VLAN interface is enabled.
In this case, the VLAN interface’s status is
determined by the status of the ports in the
VLAN, that is, if all ports of the VLAN are
down, the VLAN interface is down
(disabled); if one or more ports of the VLAN
are up, the VLAN interface is up (enabled).
If you disable the VLAN interface, the VLAN
interface will always be down, regardless of
the status of the ports in the VLAN.
The operation of enabling/disabling a VLAN’s VLAN interface does not influence the physical status of
the Ethernet ports belonging to this VLAN.
Displaying VLAN Configuration
To do... Use the command... Remarks
Display the VLAN interface
information
display interface Vlan-interface
[ vlan-id ]
Display the VLAN information
display vlan [ vlan-id [ to vlan-id ] | all |
dynamic | static ]
Available in any
view.
Configuring a Port-Based VLAN
Port-Based VLAN Configuration Task List
Complete these tasks to configure a port-based VLAN:
Task Remarks
Configuring the Link Type of an Ethernet Port Optional
Assigning an Ethernet Port to a VLAN Required
Configuring the Default VLAN for a Port Optional
Configuring the Link Type of an Ethernet Port
Follow these steps to configure the link type of an Ethernet port:
To do… Use the command… Remarks
Enter system view
system-view
—