H3C S5100-SI

2-4
To do… Use the command… Remarks
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the port link type
port link-type { access |
hybrid | trunk }
Required
The link type of an Ethernet port is
access by default.
To change the link type of a port from trunk to hybrid or vice versa, you need to set the link type to
access first.
Assigning an Ethernet Port to a VLAN
You can assign an Ethernet port to a VLAN in Ethernet port view or VLAN view.
1) In Ethernet port view
Follow these steps to assign an Ethernet port to one or multiple VLANs:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type interface-number
—
Access port
port access vlan vlan-id
Trunk port port trunk permit vlan { vlan-id-list | all }
Assign the
port to one
or multiple
VLANs
Hybrid port
port hybrid vlan vlan-id-list { tagged |
untagged }
Optional
By default, all
Ethernet ports
belong to VLAN
1.
When assigning an access or hybrid port to a VLAN, make sure the VLAN already exists.
2) In VLAN view
Follow these steps to assign one or multiple access ports to a VLAN in VLAN view:
To do…
Use the
command…
Remarks
Enter system view
system-view
—
Enter VLAN view
vlan vlan-id
Required
If the specified VLAN does not exist, this
command creates the VLAN first.