H3C S5100-SI

1-30
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface GigabitEthernet1/0/1
[Sysname-GigabitEthernet1/0/1] traffic-limit inbound ip-group 2000 128 exceed
remark-dscp 56
2) Method II: configure traffic policing for VLAN 2
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-limit vlan 2 inbound ip-group 2000 128 exceed remark-dscp 56
Configuring Traffic Shaping
Refer to Traffic Policing and Traffic Shaping for information about traffic shaping.
This feature is available only on the H3C S5100-EI series switches.
Configuration prerequisites
z The queue for which traffic shaping is to be performed has been determined.
z The maximum traffic rate and the burst size have been determined.
z The port where traffic shaping is to be configured has been determined.
Configuration procedure
Follow these steps to configure traffic shaping:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—