H3C S5100-SI

1-4
Table 1-4 Display and maintain stack configurations
Operation Command Description
Display the stack
status information on
the main switch
display stacking
[ members ]
Optional
The display command can be executed in
any view.
When being executed with the members
keyword not specified, this command
displays the main switch and the number of
switches in the stack.
When being executed with the members
keyword specified, this command displays
the member information of the stack,
including stack number , device name,
MAC addresses and status of the main
switch/slave switches.
Display the stack
status information on a
slave switch
display stacking
Optional
The display command can be executed in
any view.
The displayed information indicates that the
local switch is a slave switch. The
information such as stack number of the
local switch, and the MAC address of the
main switch in the stack is also displayed.
Stack Configuration Example
Network requirements
Connect Switch A, Switch B and Switch C with each other through their stack ports to form a stack, in
which Switch A acts as the main switch, while Switches B and C act as slave switches.
Configure Switches B and Switch C through Switch A.
Network diagram
Figure 1-1 Network diagram for stack configuration