H3C S5100-SI

1-15
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the HWPing client
function
hwping-agent enable
Required
By default, the HWPing client
function is disabled.
Create a HWPing test group
and enter its view
hwping administrator-name
operation- tag
Required
By default, no test group is
configured.
Enable the HWPing client to
send Trap messages
send-trap { all | { probefailure
| testcomplete | testfailure }* }
Required
By default, Trap sending is
disabled.
Configure the number of
consecutive unsuccessful
HWPing tests before Trap
output
test-failtimes times
Optional
By default, Trap messages are
sent each time a test fails.
Configure the number of
consecutive unsuccessful
HWPing probes before Trap
output
probe-failtimes times
Optional
By default, Trap messages are
sent each time a probe fails.
Displaying HWPing Configuration
To do… Use the command… Remarks
Display test history
display hwping history [ administrator-name
operation-tag ]
Display the results of the latest
test
display hwping results [ administrator-name
operation-tag ]
Available in
any view
HWPing Configuration Examples
ICMP Test
Network requirements
An H3C S5100-SI/EI series Ethernet switch serves as the HWPing client. A HWPing ICMP test between
the switch and another switch uses ICMP to test the round trip time (RTT) for packets generated by the
HWPing client to travel to and back from the destination switch.
Network diagram
Figure 1-2 Network diagram for the ICMP test