H3C S5100-SI

1-12
Follow these steps to configure the attempts to send an NS message for duplicate address detection:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter VLAN interface view
interface interface-type
interface-number
—
Configure the attempts to send
an NS message for duplicate
address detection
ipv6 nd dad attempts value
Optional
1 by default. When the value
argument is set to 0, the
duplicate address detection is
disabled.
Configuring the NS Interval
After a device sends an NS message, if it does not receive a response within a specific period, the
device will send another NS message. You can configure the interval for sending NS messages.
Follow these steps to configure the NS interval:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter VLAN interface view
interface interface-type
interface-number
—
Specify the NS interval
ipv6 nd ns retrans-timer
value
Optional
1,000 milliseconds by default.
Configuring the neighbor reachable timeout time on an interface
After a neighbor passed the reachability detection, the device considers the neighbor to be reachable in
a specific period. However, the device will examine whether the neighbor is reachable again when there
is a need to send packets to the neighbor after the neighbor reachable timeout time elapsed.
Follow these steps to configure the neighbor reachable timeout time on an interface:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter VLAN interface view
interface interface-type
interface-number
—
Configure the neighbor
reachable timeout time
ipv6 nd nud reachable-time
value
Optional
30,000 milliseconds by default.
Configuring a Static IPv6 Route
You can configure static IPv6 routes for network interconnection in a small sized IPv6 network.
Follow these steps to configure a static IPv6 route:
To do… Use the command… Remarks
Enter system view
system-view
—