H3C S5100-SI

2-7
Changes made to the authentication mode for console port login takes effect after you quit the
command-line interface and then log in again.
Console Port Login Configuration with Authentication Mode Being
None
Configuration Procedure
Follow these steps to configure console port login with the authentication mode being none:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter AUX user interface view user-interface aux 0 —
Configure not to authenticate
users
authentication-mode
none
Required
By default, users logging in through
the console port (AUX user interface)
are not authenticated.
Configuration Example
Network requirements
Assume that the switch is configured to allow users to log in through Telnet, and the current user
level is set to the administrator level (level 3). Perform the following configurations for users
logging in through the console port (AUX user interface).
z Do not authenticate the users.
z Commands of level 2 are available to the users logging in to the AUX user interface.
z The baud rate of the console port is 19,200 bps.
z The screen can contain up to 30 lines.
z The history command buffer can contain up to 20 commands.
z The timeout time of the AUX user interface is 6 minutes.