H3C S5100-SI

1-8
To do… Use the command… Remarks
Configure the
destination IP address
destination-ip ip-address
Required
You can configure an IP address or a
host name.
By default, no destination address is
configured.
Configure dns-server
dns-server ip-address
Required when you use the
destination-ip command to configure
the destination address as the host
name.
By default, no IP address of the DNS
server is configured.
Configure the source IP
address
source-ip ip-address
Optional
By default, no source IP address is
configured.
Configure the source
port
source-port port-number
Optional
By default, no source port is configured.
Configure the test type
test-type http
Required
By default, the test type is ICMP.
Configure the number
of probes per test
count times
Optional
By default, each test makes one probe.
Configure the
maximum number of
history records that can
be saved
history-records number
Optional
By default, the maximum number is 50.
Configure the
automatic test interval
frequency interval
Optional
By default, the automatic test interval is
zero seconds, indicating no automatic
test will be made.
Configure the probe
timeout time
timeout time
Optional
By default, a probe times out in three
seconds.
Configure the type of
service
tos value
Optional
By default, the service type is zero.
Configure the type of
HTTP operation
http-operation { get | post }
Optional
By default, the type of HTTP operation is
get, that is, the HTTP operation will get
data from the HTTP server.
Start the test
test-enable
Required
Display test results
display hwping results
[ admin-name operation-tag ]
Required
You can execute the command in any
view.
5) Configuring jitter test on HWPing client
Follow these steps to configure jitter test on HWPing client: