H3C S5100-SI

1-12
To do… Use the command… Remarks
Configure the source
port
source-port port-number
Optional
By default, no source port is specified.
Configure the test type
test-type { tcpprivate |
tcppublic }
Required
By default, the test type is ICMP.
Configure the number
of probes per test
count times
Optional
By default, one probe is made per time.
Configure the
automatic test interval
frequency interval
Optional
By default, the automatic test interval is zero
seconds, indicating no automatic test will be
made.
Configure the probe
timeout time
timeout time
Optional
By default, a probe times out in three seconds.
Configure the
maximum number of
history records that
can be saved
history-records number
Optional
By default, the maximum number is 50.
Configure the type of
service
tos value
Optional
By default, the service type is zero.
Start the test
test-enable
Required
Display test results
display hwping results
[ admin-name
operation-tag ]
Required
The display command can be executed in any
view.
8) Configuring UDP test on HWPing client
Follow these steps to configure UDP test on HWPing client:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the HWPing
client function
hwping-agent enable
Required
By default, the HWPing client function is
disabled.
Create a HWPing test
group and enter its
view
hwping administrator-name
operation- tag
Required
By default, no test group is configured.
Configure the
destination address
destination-ip ip-address
Required
This IP address and the one configured on
the HWPing server for listening service
must be the same.
By default, no destination address is
configured.